Control - The Danair AH-15-TM is a stationary air tool actuated by the pressure of the work piece against the hammer tip. When the work piece is removed, the tool will stop cycling immediately. The AH-15-TM will deliver over 1000 hammer blows per minute. Start the end of the tee molding into the kerf with finger pressure, push it against the hammer tip and advance the work piece and tee molding across the hammer tip as fast as the molding is set.

Flexible - Installs all types of tee molding from 1/8" through 2" wide onto small or large work surfaces without adjustment to the tool. Interchangeable hammer tips allow for soft or hard tee molding.

Air Consumption - Is extremely low.Continuous hammering uses approximately 3 CFM.

Quality - Since 1967 DANAIR Products have been made in the U.S. with only the finest materials. Anytime during the LIFETIME of the tool a failure occurs because of workmanship or defective materials DANAIR will repair or replace that tool.

Included - The AH- TM Table Mount Tool includes a pressure regulator and pressure gauge to adjust the air supply to the optimum level. The heavy mounting bracket allows for a strong stationary mount.